LNS update V2.18.19 of September 08, 2023

Version 2.18.19 has been available since September 08, 2023.

LNS Update

Changes between version 2.18.12 and version 2.18.19

• Iridium: bug fix: message sent in triplicate. Now, only in case of failure is a message resent up to 3 times in total.
• Adjustment to EUMETSAT (Meteosat) transmissions
• Telic LT910-WW modem: Forcing serial communication to 115200
• New units added: s, ms, min, h, W/m², µS/cm

From a PC connected to the Station:

1) Download the update ("V2.18.19_du_08_septembre_2023.zip") from the link below.

2) Log on to the station with your browser.

3) Select the "Maintenance" tab

6) Place the file "V2.18.19_du_08_septembre_2023.zip" in the dotted "Firmware file" area.

7) Click on "Load firmware into station".

8) Follow the information on the screen.

9) Do not switch off the power supply during the procedure, as the station will restart by itself once the update is complete.

10) In order to connect to the station via USB, once the station has been updated, it may be necessary to reinstall the USB driver on the PC, depending on the original version.

Note: Settings files from previous versions are not compatible with version 2. However, in the case of an upgrade from version 1.6 or higher to version 2, the parameters present in the SNSL will be automatically converted to the new

With the help of a USB key:

1) Download the update from the link.

2) Unzip the file "V2.18.19_du_08_septembre_2023.zip".

3) Copy the contents of the file directly onto a USB stick (raw without folder)

4) Insert the key on the LNS

5) On the station display, in the "Read from USB stick" menu, select "Firmware".

6) Click on "Yes" and follow the on-screen instructions.

7) Do not switch off the power supply during the procedure, as the station will restart by itself once the update is complete.

8) In order to connect to the station via USB, once the station has been updated, it may be necessary to reinstall the USB driver on the PC, depending on the original version.

Note 1 Firmware must not be "zipped" and must be located at the root of the key (= not in a folder).
Note 2 Parameter files from previous versions are not compatible with version 2. However, when upgrading from version 1.6 or higher to version 2, the parameters in the LNS will be automatically converted to the new format.